Logo Watercel ZF

Remove safely iron and manganese from water with Watercel ZF

Watercel ZF acts directly to remove soluble (Fe2+ and Mn2+) and particulate (Fe3+ and Mn4+) iron and manganese present in water.

  • Particle size: 0.4 to 1.0 mm
  • Uniformity coefficient: 1 to 1.9
  • Apparent density: 0.9 – 1.0 g/cm³
  • pH: 2.5-5.0
  • Color: Brown
  • Moisture content: ≤ 12%
  • Melting point: 1000 – 1400 °C
Banner watercel ZF
Watercel ZF Safe product

Safe product. Safety tested according to GM/MS Standard No. 888/21, based on NSF/ANSI Standard 61 (2016).

Watercel ZF High production Watercel

Increased water production due to high filtration rates.

Water savings Watercel ZF

Reduced backwash water consumption due to low backwash requirements.

Porosity Watercel ZF

Lower pressure drop due to high porosity, which promotes greater water production capacity.

Adsortion capacity Watercel ZF

High iron and manganese adsorption capacity using lower quantities of product per cubic meter of water treated.

Recommended use

Filtration rate 10 to 30 m³/m².h
Backwash rate 25 to 35 m³/m²·h
Filter expansion 20 to 30%

pH
6.0 to 8.5 (6 to 7.5 up to 2 ppm of Mn.
For values above this, use a pH between 8.0 and 8.5).
Work with a pH of 7.5 for iron ≥ 4.0 ppm.
Apparent density 0,98 kg/L (g/cm³)

Bed support
Use only 1/8 to 1/16 gravel (minimum height of 200 mm)
or use Zeomedia 4-6 and 1/8 to 1/16 gravel (minimum height
of 100 mm for each particle size)
Maximum concentrations ≤ 11,0 mg/L iron.
≤ 6,0 mg/L manganese
Maximum permissible
turbidity at the filter inlet
≤ 10 NTU
Outlet free chlorine
1,0 to 2,0 mg/L

Casos de éxito

Zeomedia guarantee promise

We identify ways your system can be optimized and show you different high-performance options so you can save on your daily operations. Written guarantee.

Frequently Asked Questions

We perform calculations and simulations to ensure accurate forecasts. We also have extensive experience with various client success stories that have been satisfied thanks to our technical support.

We know that every project is different and each one incorporates specific variables. Contact us for a technical consultation.

If the projected savings aren’t achieved, we’ll either provide the savings or refund your investment. Visit our dedicated section for terms and conditions.